Filter
Top Products
and an M10 Nylon Locknut (11). Note: Do not over-
tighten the Nylon Locknut; the Backrest Tubes
must pivot easily.
Tube 6
27
20. Attach theBackrest (15) to the Backrest Tubes (27)
with tour M6 x 55ram Bolts (4) and four M8 Washers
(3O).
2O
15
: 27
21. Press a 25ram x 5Ornm inner Cap (58) into the open
end of the Seat Support Tube (37).
Lubricate an M8 x 80mm Bolt (9). Attach the Seat
Adjustment Bracket (45) to the indicated side of the
Seat Support Tube (37) with the Bolt and an M8
Nylon Locknut (54). Note: Do not overtighten the
Nylon Leeknut; the Seat Adjustment Bracket must
pivot easily.
21
9
Lubricate
58
45
37
54
22. Place the S_a_tSupport Tube (37) on the Bench
Frame (5) so that the Seat Adjustrrfent Bracket (45)
fits over the welded pin (not visible in tbe drawing) on
the side of the Bench Frame.
Lubricate an M10 x 80mm Bolt (56). Attach the Seat
Support Tube (37) to the indicated bracket on the
Bench Frame (5) with the Belt and an M10 Nylon
Locknut (11)+ Note: Do not overtighten the Nylon
Locknut; the Seat Support Tube must pivot easily•
22
37_ Lubricate
45
56
Welded
Pin
-@
\
11
12 ": • -