Filter
Top Products
15. Press a 50mm Square Outer Cap (17) onto each end
of the Small Stabilizer (25).
Attach the Small Stabilizer (25) to the Bench Frame
(5) with two M10 x 65mm Carriage Bolts (40) and two
M10 Nylon Locknuts (11). Note: There is an inden-
tation around the holes on one side of the Small
Stabilizer. This side must be facing the floor.
15
40
11
5
17
17
25
16. Press a 50mm x 70mm Outer Cap (10) onto each
end of the Large Stabilizer (26).
Turn the Large Stabilizer (26) so the warning decal is
in the position shown. Attach the Large Stabilizer to
the Bench Frame (5) with two M10 x 65mm Carriage
Bolts (40) and two M10 Nylon Locknuts (11).
16
40
5
10
11
Decal
10
26
17. Press two 20mm x 40mm Inner Caps (28) into each
Backrest Tube (27). Press four 20mm x 40mm Inner
Caps into the Backrest Adjustment Bracket (36).
Lubricate an M10 x 180mm Bolt (22). Attach the
Backrest Tubes (27) to the welded tube on the
Backrest Adjustment Bracket (36) with the Bolt, two
M10 Washers (6), and an M10 Nylon Locknut (11).
Make sure that the Backrest Tubes are turned as
shown. The indicated holes are not centered in
the Backrest Tubes but are closer to one side.
Turn the Backrest Tubes so the holes are closer
to the floor. Do not overtighten the Nylon Locknut;
the Backrest Tubes must pivot easily.
18. Lubricate an M10 x 115mm Bolt (55). Slide an M10
Washer (6) onto the Bolt.
Attach the Backrest Adjustment Bracket (36) to the
bracket on the Bench Frame (5) by guiding the M10 x
115mm Bolt (55) through the indicated side of the
Backrest Adjustment Bracket (36), the bracket on the
Bench Frame (5), and the 15mm x 10.2mm x 60mm
Spacer (57). Next, insert the Bolt through the other
side of the bracket and the other side of the Backrest
Adjustment Bracket. Secure the Bolt with an M10
Washer (6) and an M10 Nylon Locknut (11). Do not
overtighten the Nylon Locknut.
17
28
28
6
11
36
Lubricate
6
Holes
Welded
Tube
28
28
22
27
18
6
36
57
5
11
6
55
27
Lubricate
Bracket
11