Filter
Top Products
12
INTRODUCTION
IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
TREADMILL
OPERATION
LIMITED
WARRANTY
TROUBLESHOOTING
& MAINTENANCE
CONDITIONING
GUIDELINES
A S S E M B LY S T E P 5
CONSOLE MAST
CONSOLE
SET SCREWS (J)
HANDLEBAR
BOLT (K)
ARC WASHER (L)
SET SCREW (J)
12 mm
Qty: 4
BOLT (K)
120 mm
Qty: 2
ARC WASHER (L)
17 mm
Qty: 2
angle view
HARDWARE BAG 5 CONTENTS :
A Open HARDWARE BAG 5.
B Slide LEFT HANDLEBAR to CONSOLE and attach using 2 SET SCREWS (J).
C Attach LEFT HANDLEBAR to CONSOLE MAST using 1 BOLT (K) and 1 ARC WASHER (L).
D Repeat on other side.
NOTE: Look into holes in the right mast before inserting bolts to avoid pinching cables.
Y O U ’ R E F I N I S H E D !
POWER SWITCH
CIRCUIT BREAKER
Connect power plug to the treadmill
and connect the cord to a power
outlet. The on/off switch is located
next to the power cord. Flip this
switch to the 'ON' position, so that
the switch is lit. You will hear a beep
and the console will turn on.
CONSOLE MAST
CONSOLE
SET SCREWS (J)
HANDLEBAR
BOLT (K)
ARC WASHER (L)