Filter
Top Products
12
INTRODUCTION
IMPORTANT
PRECAUTIONS
BEFORE
YOU BEGIN
TREADMILL
OPERATION
LIMITED
WARRANTY
TROUBLESHOOTING
& MAINTENANCE
CONDITIONING
GUIDELINES
ASSEMBLY
BEFORE
YOU BEGIN
ASSEMBLY
13
INTRODUCTION
IMPORTANT
PRECAUTIONS
TREADMILL
OPERATION
CONDITIONING
GUIDELINES
TROUBLESHOOTING
& MAINTENANCE
LIMITED
WARRANTY
YOU ’R E F IN I SH E D!
CIRCUIT BREAKER
ON/OFF SWITCH
AS SE MB LY ST E P 5
FLAT WASHERS (B)
SPRING WASHERS (C)
BOLTS (G)
CONSOLE
HANDLEBAR BRACKET
RIGHT SIDE:
CONNECT CONSOLE
CABLES, PULSE CABLES
AND POWER CABLES
LEFT SIDE:
CONNECT PULSE
CABLES ONLY
FLAT WASHER (B)
8 mm
Qty: 4
SPRING WASHER (C)
8 mm
Qty: 4
BOLT (G)
16 mm
Qty: 4
HARDWARE BAG 5 CONTENTS:
Open HARDWARE BAG 5.
Place CONSOLE onto HANDLEBAR
BRACKETS as shown.
NOTE:
Do not pinch CONSOLE CABLE
when placing the console onto the
handlebar brackets.
Insert 2 BOLTS (G), 2 SPRING
WASHERS (C) and 2 FLAT WASHERS
(B) through the bottom of the
HANDLEBAR BRACKET to secure the
console to the HANDLEBAR BRACKET.
Repeat on other side.
Reach inside the right underside of
the console to pull out the CONSOLE
CABLE, PULSE CABLE and POWER
CABLE. Attach to the matching cables
that are hanging out of the cable hole
in the handlebar.
Repeat on left side to attach PULSE
CABLE.
Thread attached cables back through
the cable holes when finished.
A
B
C
D
E
F
G
AS SE MB LY ST E P 6
FLAT WASHERS (B)
SPRING WASHERS (C)
BOLTS (A)
ARC WASHER (D)
SPRING WASHER (C)
BOLT (A)
SUPPORT BAR
MAIN FRAME
HANDLEBAR
Open HARDWARE BAG 6.
With the running deck in the
lowered position, place the
SUPPORT BAR between the
HANDLEBAR and the MAIN
FRAME.
To attach the SUPPORT BAR,
insert 1 BOLT (A), 1 SPRING
WASHER (C) and 1 ARC
WASHER (D) in the top of the
SUPPORT BAR and 2 BOLTS
(A), 2 SPRING WASHERS (C)
and 2 FLAT WASHERS (B) in
the bottom of the SUPPORT
BAR as shown.
Repeat on the other side
Connect power plug to the
treadmill and connect the
cord to a power outlet. The
on/off switch is located next
to the power cord. Flip this
switch to the 'ON' position, so
that the switch is lit. You will
hear a beep and the console
will light up.
Before the first use, lubricate
the treadmill deck by
following the instructions in
the Maintenance section.
A
B
C
D
E
F
FLAT WASHER (B)
8 mm
Qty: 4
SPRING WASHER (C)
8 mm
Qty: 6
ARC WASHER (D)
8 mm
Qty: 2
BOLT (A)
20 mm
Qty: 6
HARDWARE BAG 6 CONTENTS:
NOTE: Do not completely tighten any
bolts until step 6 is complete!
T1201_Rev.1.7.indd 12-13 7/31/08 4:52:44 PM