Filter
Top Products
8
INTRODUCTION
IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
TREADMILL
OPERATION
LIMITED
WARRANTY
TROUBLESHOOTING
& MAINTENANCE
CONDITIONING
GUIDELINES
Disassemble box and remove the cardboard packaging that is not beneath the treadmill. Do not attempt to
lift the treadmill at this time. Remove plastic wrap from console masts.
*NOTE: During each assembly step, ensure that ALL nuts and bolts are in place and partially threaded in
before completely tightening any ONE bolt. NOTE: A light application of grease may aid in the installation of
hardware. Any grease, such as lithium bike grease is recommended.
Open HARDWARE BAG 1.
Pull LEAD WIRE through RIGHT
CONSOLE MAST to drag upward.
Place RIGHT CONSOLE MAST
into upright position using 2
BOLTS (A) and 2 FLAT WASHERS
(B), then tighten. Be sure to
hold the CONSOLE MAST firmly,
as it will not stay in the upright
position on its own.
*NOTE: Do not pinch CONSOLE
CABLE when placing the mast
onto the main frame.
Repeat on the left side.
*NOTE: There is no wire in the
LEFT CONSOLE MAST.
P R E - A S S E M B LY
A S S E M B LY S T E P 1
A)
B)
C)
D)
BOLT (A)
65 mm
Qty: 4
FLAT WASHER (B)
Qty: 4
HARDWARE BAG 1 CONTENTS :
CONSOLE CABLELEAD WIRE RIGHT CONSOLE MAST
CONSOLE MAST
BOLT (A)
FLAT WASHERS (B)