Filter
Top Products
6
INTRODUCTION
IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
TREADMILL
OPERATION
LIMITED
WARRANTY
TROUBLESHOOTING
& MAINTENANCE
CONDITIONING
GUIDELINES
7
INTRODUCTION
IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
TREADMILL
OPERATION
CONDITIONING
GUIDELINES
TROUBLESHOOTING
& MAINTENANCE
LIMITED
WARRANTY
ASSEMBLY
IMPORTANT: READ THESE SAFETY INSTRUCTIONS BEFORE USE!
It is very important to follow the assembly instructions correctly and to make sure all parts are firmly
tightened. If the assembly instructions are not followed correctly, the treadmill could have frame parts that
are not tightened and will seem loose and may cause irritating noises. There should be no side-to-side play
in the console masts or any forward and back play in the console assembly or handlebars. If there is any
play in these areas, the treadmill has not been properly assembled. To prevent damage to the treadmill, the
assembly instructions must be reviewed and corrective actions should be taken.
UNPACKING
Place the treadmill carton on a level flat surface. It is recommended that you place a protective covering on
Once the banding straps have been removed, do not lift or transport this unit unless it is fully assembled
enclosed treadmill is equipped with high-pressure shocks and may spring open if mishandled. Never grab
Before proceeding, find your treadmill’s serial number
and model name located under the deck on the frame
crossbar and enter it in the space provided below.
ENTER YOUR SERIAL NUMBER AND
MODEL NAME IN THE BOXES BELOW:
* Refer to the and when calling for service.
* Also enter this serial number on your Warranty Card.
TOOLS INCLUDED
PARTS INCLUDED
READING RACK
REMOVABLE CD / MP3 STORAGE
GRIP PULSE HANDRAILS
HANDLEBAR
ON/OFF SWITCH
CIRCUIT BREAKER
TRANSPORT WHEEL
ADR2
™
CUSHIONING
SUPPORT BAR
POWER CORD
CONSOLE
SPEAKERS
FAN
SAFETY KEY PLACEMENT
MOTOR COVER
RUNNING BELT / RUNNING DECK
SIDE RAIL
ROLLER END CAP
CONSOLE MAST
REAR ROLLER
ADJUSTMENT BOLTS
FOOT LOCK LATCH
WATER BOTTLE HOLDER
If you have questions or if there are any missing parts, contact Customer Tech Support.
Contact information is located on the back panel of this manual.
For a complete exploded diagram, visit us at www.horizonfitness.com
c 4 mm L-wrench
c 5 mm T-wrench
c 6 mm T-wrench
(Used to adjust the rear roller adjustment bolts.)
c 10 mm L-wrench
c 17mm Flat Wrench
c 1 Console Assembly
(located under treadmill deck)
c 2 Console Masts
c 1 Support Bar
c 2 Handlebars
c 5 Hardware Bags
c 1 Bottle of Silicone Lubricant
c 1 Power Cord
c 1 Audio Adaptor Cable
c 1 Safety Key
WA RNING
GS_1035T_Treadmill_Rev.2.3.indd 6-7 6/13/07 11:17:33 AM