Filter
Top Products
BEFORE
YOU BEGIN
6
INTRODUCTION
IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
ELLIPTICAL
OPERATION
LIMITED
WARRANTY
TROUBLESHOOTING
& MAINTENANCE
CONDITIONING
GUIDELINES
BEFORE
YOU BEGIN
ASSEMBLY
7
INTRODUCTION
IMPORTANT
PRECAUTIONS
ELLIPTICAL
OPERATION
CONDITIONING
GUIDELINES
TROUBLESHOOTING
& MAINTENANCE
LIMITED
WARRANTY
GUIDE RAILS
BOLT (B)
MAIN FRAME
FRONT STABILIZER TUBE
BOLT (A)
TOOLS INCLUDED PARTS INCLUDED
c 5mm Allen Wrench
c 4mm Allen Wrench
c Phillips Screw Driver
c 13/15mm Flat Wrench
c T Wrench
c 1 Console
c 1 Console Mast
c 1 Front Stabilizer Tube
c 1 Left Handlebar
c 1 Right Handlebar
c 2 Lower Link Arms
c 2 Pivoting Foot Pads
c 1 Top Cover
c 1 HORIZON FITNESS
12-volt Power Supply
CONSOLE
RIGHT HANDLEBAR
LOWER HANDLEBAR
LOWER LINK ARM
FRONT STABILIZER TUBE
PULSE GRIP
CONSOLE MAST
DISPLAY
PIVOTING FOOT PAD
PEDAL ARM
c 7 Hardware Bags
c 2 Handlebar Covers
c 2 Elbow Covers
c 2 Footpad Brackets
c 2 Footpad Rubber Inserts
c Water Bottle
BOTTLE HOLDER
If you have questions or if there are any missing parts, contact Customer Tech Support.
Contact information is located on the back panel of this manual.
For a complete exploded diagram, visit us at www.horizonfitness.com
HANDLEBAR COVERS
ELBOW COVER
CONSOLE MAST BOOT
TOP COVER
LEFT HANDLEBAR
A S S E M B LY S T E P 1
A) Open HARDWARE BAG FOR STEP 1.
B) Extend the GUIDE RAILS away from the MAIN FRAME until bolt holes line up.
C) Secure GUIDE RAILS using 2 BOLTS (B).
D) Attach the FRONT STABILIZER TUBE to the MAIN FRAME using 2 BOLTS (A).
BOLT (A)
20 mm
Qty: 2
BOLT (B)
15 mm
Qty: 2
HARDWARE BAG FOR STEP 1 CONTENTS :
E6_Rev.1.2.indd 6-7 8/7/06 4:43:29 PM