Filter
Top Products
BEFORE
YOU BEGIN
26
INTRODUCTION
IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
ELLIPTICAL
OPERATION
HORIZON
WARRANTY
TROUBLESHOOTING
& MAINTENANCE
CONDITIONING
GUIDELINES
ASSEMBLY
CONDITIONING
GUIDELINES
TROUBLESHOOTING
& MAINTENANCE
BEFORE
YOU BEGIN
ASSEMBLY
27
INTRODUCTION
ELLIPTICAL
OPERATION
CONDITIONING
GUIDELINES
HORIZON
WARRANTY
IMPORTANT
PRECAUTIONS
M O N T H LY L O G S H E E T S
M ONT H M ONT H LY GO A L
M ONT H LY TO TA L S :
W EEK # D IST ANC E C ALO R IES T IME
M ONT H M ONT H LY GO A L
M ONT H LY TO TA L S :
W EEK # D IST ANC E C ALO R IES T IME
M ONT H M ONT H LY GO A L
M ONT H LY TO TA L S :
W EEK # D IST ANC E C ALO R IES T IME
Your Horizon Series elliptical is designed to be reliable. However, if you do experience problems with your
elliptical, please reference the troubleshooting guide listed below.
PROBLEM: The console does not turn on.
SOLUTION: Verify the following:
• The outlet the machine is plugged into is functional. Double check that the breaker has not tripped.
• The correct adapter is being used. Only use the adapter provided or authorized by Horizon Fitness.
• The adapter is not pinched or damaged and is properly plugged into the outlet AND the machine.
• Unplug power cord. Remove the console and check that all connections to the console are secure and not damaged
or pinched.
NOTE: If your console uses batteries, they may need to be replaced.
PROBLEM: The console turns on but the Time/RPM’s do not count.
SOLUTION: Verify the following:
• Unplug power cord. Remove the console and check that all connections to the console are secure and not damaged
or pinched.
• If doing the above does not fix the problem, the speed sensor and/or magnet may have become dislodged or
damaged.
PROBLEM: The resistance levels seem to be incorrect, seeming too hard or too easy.
SOLUTION: Verify the following:
• The correct adapter is being used. Only use the adapter provided or authorized by Horizon Fitness.
• Reset the console and allow the resistance to reset to the default position. Restart and retry the resistance levels.
PROBLEM: The roller wheels appear to be leaving particles on the guide rails.
SOLUTION: This is considered normal wear of the elliptical wheels.
To remove, simply wipe off the roller wheels and guide rails with a damp cloth.
PROBLEM: The elliptical makes a squeaking or chirping noise.
SOLUTION: Verify the following:
• The elliptical is on a level surface.
• Loosen all bolts attached during the assembly process, grease the threads, and tighten again.
T R O U B L E S H O O T I N G
E401_Rev.1.5.indd 26-27 2/29/08 10:05:46 AM