Horizon Fitness CST3 Treadmill User Manual


 
5
Before proceeding, find your treadmill’s serial number and model name located to the left of the on/off
power switch and power cord and enter it in the space provided below and be sure to read the Safety
Instructions and complete User’s guide section before using your new treadmill:
ENTER YOUR SERIAL NUMBER AND MODEL NAME IN THE BOX BELOW:
IMPORTANT: PLEASE READ BEFORE USE!
CAUTION!
There are several areas during the assembly process of a the treadmill that special
attention must be paid. It is very important to follow the assembly instructions correctly and to make
sure all parts are firmly tightened. If the assembly instructions are not followed correctly, the
treadmill could have frame parts that are not tightened and will seem loose and may cause irritating
noises. There should be no side-to-side play in the console masts or any forward and back play in the
console assembly or handlebars. If there is any play in these areas, the treadmill has not been prop-
erly assembled. To prevent damage to the treadmill, the assembly instructions must be reviewed and
corrective actions should be taken.
UNPACKING
Place your treadmill on a level flat surface. It is recommended that you place a protective covering on
your floor. Take CAUTION when handling and transporting this unit. Never open box when it is on its
side. Once the banding straps have been removed, do not lift or transport this unit unless it is fully
assembled and in the upright folded position, with the lock latch secure. NOTE: The console assem-
bly is located under the treadmill deck and should ONLY be removed after STEP 1 of the assembly
instructions have been fully completed!
FAILURE TO DO SO MAY RESULT IN SERIOUS INJURY!
Unpack the unit where it will be used. The enclosed treadmill is equipped with high-pressure shocks
and may spring open if mishandled. Never grab hold of any portion of the incline frame and attempt
to lift or move the treadmill.
FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN
INJURY!
Assembly
Refer to the serial number and model name when calling for service, also enter this serial number on
your Warranty Card.