Horizon Fitness 2.2T Treadmill User Manual


 
BEFORE
YOU BEGIN
8
INTRODUCTION
IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
TREADMILL
OPERATION
LIMITED
WARRANTY
TROUBLESHOOTING
& MAINTENANCE
CONDITIONING
GUIDELINES
BEFORE
YOU BEGIN
ASSEMBLY
9
INTRODUCTION
TREADMILL
OPERATION
CONDITIONING
GUIDELINES
TROUBLESHOOTING
& MAINTENANCE
LIMITED
WARRANTY
IMPORTANT
PRECAUTIONS
Open HARDWARE BAG 1.
Raise the CONSOLE MAST to the
vertical position. Be sure to hold
the console mast firmly, as it
will not stay in the upright
position on it’s own.
Move LEFT SIDE LINKAGE ARM
into position. Insert BOLT (A)
and tighten. Slide LINK ARM
COVER over LOWER LINK ARM
joint.
Repeat on the right side.
Now cut the banding straps and
remove remaining packaging
material.*
* NOTE: If the straps have been removed
before completing step 1-D and the
linkage arms cannot be aligned,
refer to the TROUBLESHOOTING
section (page 35) in order to restore
the treadmill to its proper position.
A S S E M B LY S T E P 1

A S S E M B LY S T E P 3


ASSEMBLY
1. 2T A S S E M B LY
A S S E M B LY S T E P 2
P R E - A S S E M B LY
WARNING
DO NOT CUT STRAPS UNTIL STEP 1-E!* Disassemble box and remove the cardboard
packaging that is not beneath the treadmill. Do not attempt to lift the treadmill at this
time. Remove plastic wrap from console masts.
NOTE: It is recommended that you apply grease to the threads of each bolt as you assemble your treadmill, to prevent
loosening and noise. Also, during each assembly step, ensure that ALL nuts and bolts are in place and partially
threaded in before completely tightening any ONE bolt.
A
B
C
D
E




 





HARDWARE BAG 1 CONTENTS :




 

Open HARDWARE BAG 2.
Lift CONSOLE (as shown) to lock
it into place.
Insert BOLT (B) through
CONSOLE MAST and secure
using NUT (C).
Repeat on other side.
Note: Do not pinch the wires.







HARDWARE BAG 2 CONTENTS :
A
B
C
D



HARDWARE BAG 3 CONTENTS :
Open HARDWARE BAG 3.
Place CONSOLE MAST COVERS
over CONSOLE MASTS as shown.
Attach CONSOLE MAST COVERS
using 6 BOLTS (D)
.
Place WATER BOTTLE HOLDERS
and SAFETY KEY into the correct
positions. It is now safe to plug
in your treadmill.
A
B
C
D



Y O U ’ R E F I N I S H ED !
Elite 1.2T-5.2T Rev 1.4.indd 8-9 8/2/05 2:47:01 PM