Filter
Top Products
ASSEMBLY
INSTRUCTIONS
FRAME ASSEMBLY
In this step attach two Flange Bearings to the Weight Cage. Make sure to
put zerk fitting facing down on Flange Bearings. Next attach the 1” Dia.
CRS to the Cam Assembly (Large). Slide the other side of the 1” Dia. CRS
through the Flange Bearings and the Weight Cage. Attach the Range of
Motion, Extension Tube Assembly, and a Red Iodized Aluminum Cap to
the 1” Dia. CRS. bolts only, they will be tightened later.
Lift Machine to position Rubber Feet.
Hand Tighten
Step 2a
2 - Range of Motion
4 - Extension Tube Assembly
6 - Cam Assembly (Large)
7 - Weight Cage
12 - 1” Dia. CRS
23 - Rubber Feet
34 - Red Iodized Aluminum Cap
36 - Black Plastic Ring
Part Descriptions
D - 3/8” x 1 1/4” Flat Head Screw
E - 3/8” x 1 1/4” Button Head Screw
T - 3/8” Lock Washer (black)
W - 3/8” x 2 Open Roll Pin
X - 1” Dia. X .8mm Shims
AH - Flange Bearing
BE - 3/8” Flat Washer
Hardware Descriptions
FITNESS SYSTEMS
R
HOIST
Page - 5 2408 Assembly