Filter
Top Products
ASSEMBLY
INSTRUCTIONS
FRAME ASSEMBLY
In this step, start by sliding one 1 ¼” dia. x 3/8” Aluminum Ring on each side of
the Handle Assembly. Then, slide on one 1.25” O.D. x 1.030” I.D. x 8.25” Comfort grip
on each side. Placea1¼Dia. x 3/4” Aluminum Cap on the end of the Handle Assembly.
Once all three pieces(per side) are in place, secure the End Caps, slide the Comfort
Grip flush with the End Caps, and slide the Aluminum Rings flush with the Comfort
Grip and secure. Next, secure a 1 3/8” Dia. Flat Head Cap to the elbow of the Arm
Assembly. Then attach the two Flange Bearings to the Weight Cage. Make sure to put
zerk fitting facing down on Flange Bearings. Then, press both 1” Oilite Bushings on
the ends of the Handle Assembly. Now attach the Pivot Assembly to the Arm Assembly.
Slide one Metal Shim Washer on to the shaft of the Pivot Assembly. Attach the
play and the Hand Bar still
moves freely. Slide the entire Arm Assembly through the Flange Bearings and the
Weight Cage, insert the end into the Cam Assembly and secure with the 3/8” x 2” Open
Roll Pin. bolts only, they will be tightened later.Hand Tighten
Handle
Assembly to the Pivot Assembly and slide on another Shim Washer, place a 1 3/8”
diameter Flat Head Cap and secure, then check for side to side play. If there is play,
remove the Handle Assembly and add another Shim Washer to each side of the Handle
Assembly. Repeat if necessary until there is no noticeable
Step 2b
FITNESS SYSTEMS
R
HOIST
3 - Arm Assembly
4 - Pivot Assembly
5 - Handle Assembly
6 - Cam Assembly
28 - Black Plastic Ring
Part Descriptions
C - 3/8” x 1” Flat Head Cap Screw
D - 3/8” x 1 1/4” Button Head Screw
E - 3/8” Flat Washer
H - 3/8” x 3/4” Socket Head Cap Screw
P - 3/8” Lock Washer
V - 3/8” x 2” Open Roll Pin
W - 3/8” Lock Washer
X - 1” I. D. x .8mm Thick Metal Shim Washer
Y
AA - 1 3/8” Dia. Flat Head Cap, 3/8”I. D. x 5/16” Thick
AB - 1” I.D. Oilite Bushing
AC - Flange Bearing
AN - 1.25” O.D. x 1.03 I.D. x 8.25 Comfort Grip
AU - 1 1/4” dia. x 3/4” Aluminum Cap
AV-11/4”d
M - 3/8” x 3/4” Button Head Screw
- #10-32 Set Screw
ia. x 3/8” Aluminum Ring
BD - 1 5/8” Dia. Aluminum Flat Head Cap, Red
Hardware Descriptions
Page - 7 2103 Assembly