Filter
Top Products
4. Slide the Front Seat Frame (8) onto the indi-
cated 5/16” x 2 1/2” Carriage Bolts (49) in the
Press Base (13). Hand tighten two 5/16”
Nylon Locknuts (40) onto the Carriage Bolts.
Attach the other end of the Front Seat Frame
(8) to the Leg Press Upright (4) with two 5/16”
x 2 3/4” Bolts (55), two 5/16” Washers (20),
and two 5/16” Nylon Locknuts (40).
Press a 2” Square Inner Cap (56) into the
Front Seat Frame (8).
5. Insert two Weight Guides (23) into one of the
brackets on the Weight Base (14). Attach the
lower ends of the Weight Guides with a 5/16”
x 6” Bolt (67), two 1/2” x 3/4” Spacers (69),
and a 5/16” Nylon Locknut (40). Do not over-
tighten the Nylon Locknut.
Attach the other Weight Guides (23) in the
same manner.
6. Slide a Weight Bumper (27) onto each of the
Weight Guides (23).
Slide eight Weights (90) onto each set of
Weight Guides (23). Be sure that the pin
grooves are on the indicated side of each
stack of Weights.
7. Press a Weight Tube Bumper (26) into each
Weight Tube (25).
Insert a Weight Tube (25) into each stack of
Weights (90). Be sure that the pins on the
Weight Tubes are in the pin grooves in the
upper Weights.
7
6
7
FRAME ASSEMBLY
90
90
Pin
Grooves
27
27
23
23
26
25
Pin
Grooves
90
90
5
67
69
23
23
40
14
4
55
20
49
40
56
8
40
4
13