Filter
Top Products
15
32. Route the Press Cable (88) over the indicated
3 1/2” Pulley (82) attached to the Pulley
Plates (31). The Cable must be routed from
the direction shown. Refer to the inset draw-
ing. Be sure that the Cable is between the
Cable Trap (80) and the Pulley, and that the
Cable Trap is positioned to hold the Cable
in place.
Tighten the 3/8” x 2” Bolt (50) and the 3/8”
Nylon Locknut (not shown).
33. Route the Press Cable (88) around a 3 1/2”
Pulley (82). Attach the Pulley and a Cable
Trap (80) to the Leg Press Upright (4) with a
3/8” x 3 3/4” Bolt (76), a 3/8” Washer (38) and
a 3/8” Nylon Jam Nut (43). Be sure that the
Cable Trap is turned to hold the Cable in
place.
34. Route the Press Cable (88) over the indicated
3 1/2” Pulley (82) attached to the Press
Frame (12). Tighten the 3/8” x 3 1/2” Bolt (66)
and the 3/8” Nylon Locknut (not shown).
35. Wrap the Press Cable (88) around a “V”
Pulley (81). Attach the “V” Pulley to the upper
bracket on the Leg Press Upright (4) with a
3/8” x 2 1/4” Bolt (97) and a 3/8” Nylon Jam
Nut (43).
33
34
35
CABLE ASSEMBLY
32
31
82
50
88
80
88
82
88
88
66
12
82
88
81
4
97
43
38
43
4
80
76