Filter
Top Products
THE PRESET PROGRAMS
Insert the key fully into the console.
See HOW TO TURN ON THE POWER on page 10.
Select one of the four preset programs.
When the key is
inserted, the
manual mode
will be selected
and the manual
indicator will
light. To select
one of the pre-
set programs,
press the Select
Workout button repeatedly until one of the four
preset program indicators lights.
The profiles on the console show how the speed
and incline of the treadmill will change during the
preset programs—the white profiles show speed
settings and the green lines show incline settings.
The numbers at the left ends of the profiles show
the speed and incline ranges for the programs.
For example, during the Healthwalk program, the
speed of the walking belt will be from 2 mph to 4
mph and the incline will be from 1.5% to 6%. The
Time/Segment Time display will show how long
the selected program will last.
Press the Start button or the Speed
▲▲
button
to start the program.
A moment after the button is pressed, the tread-
mill will automatically adjust to the first speed and
incline settings for the program. Hold the handrails
and begin walking.
Each program is di-
vided into several time
segments of different
lengths. The Time/
Segment Time display
will show both the time
remaining in the program and the time remaining
in the current segment. One speed setting and
one incline setting are programmed for each seg-
ment. When only three seconds remain in the first
segment of the program, a series of tones will
sound and the treadmill will automatically adjust to
the speed and incline settings for the second seg-
ment.
The program will continue in this way until the
Time/Segment Time display counts down to zero.
The walking belt will then slow to a stop.
If the speed or incline setting for the current seg-
ment is too high or too low, you can manually
override the setting by pressing the Speed or
Incline buttons on the console. However, when
the next segment begins, the treadmill will au-
tomatically adjust to the speed and incline set-
tings for the next segment.
To stop the program temporarily, press one of the
Stop buttons. All displays will pause and the Time/
Segment Time display will begin to flash. To
restart the program, press the Start button or the
Speed
▲▲
button. To end the program, press a Stop
button, remove the key, and then reinsert the key.
Follow your progress with the four displays.
Refer to step 5 on page 11.
When the program has ended, remove the key.
Step onto the foot rails and make sure that the in-
cline of the treadmill is at 1.5%. The incline must
be at 1.5% when the treadmill is raised to the
storage position. Next, remove the key from the
console and put it in a safe place. Note: If the dis-
plays and indicators on the console remain lit
after the key is removed, the console is in the
“demo” mode. Refer to page 20 and turn off the
demo mode.
When you are finished using the treadmill, move
the on/off switch near the power cord to the off
position and unplug the power cord.
5
4
3
2
1
12