Filter
Top Products
6
3
2
1
74
39
47
47
52
52
3. Slide the Console Collar (6) up onto the Upright (2).
Make sure that the Console Collar is oriented exactly
as shown, with the decal on the indicated side.
While another person holds the Upright (2) in the posi-
tion shown, connect the Upper Wire Harness (39) to
the Lower Wire Harness (74). Carefully pull the
upper end of the Upper Wire Harness to remove
any slack. While holding the Upper Wire Harness,
slide the Upright onto the Frame (1). Be careful not to
pinch the Wire Harnesses.
Attach the Upright (2) to the Frame (1) with four M8 x
25mm Button Screws (47) and four M8 Split Washers
(52).
4. Connect the wire harness on the Handgrip Pulse
Sensor (5) to the indicated wire harness on the
Console (4). Insert both wire harnesses into the open-
ing in the bottom of the Console.
Refer to the inset drawing. Insert the metal tube on the
Handgrip Pulse Sensor (5) into the metal bracket inside
the Console (4) as shown. Be careful not to pinch the
wire harnesses. Align the holes in the metal tube with
the holes in the metal bracket, and tighten two M4 x
16mm Screws (63) into the indicated holes.
Snap the bookrack onto the Console (4) in the location
shown.
5
4
Bookrack
Wire Harnesses
4
Make sure the
Wire Harnesses
(39, 74) do not
get pinched dur-
ing this step.
63
Bracket
Tube
63
5
4
6
Decal
2. While another person lifts the Rear Frame (3), attach
the Rear Stabilizer (10) to the Rear Frame with two
M8 x 25mm Button Screws (47) and two M8 Split
Washers (52).
10
2
47
47
52
52
3