Filter
Top Products
20
Inspect and properly tighten all parts of the exercise
cycle regularly. To clean the exercise cycle, use a
soft, damp cloth. Keep liquids away from the console
and keep the console out of direct sunlight to prevent
damage to the console.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted. To adjust the reed
switch, you must first remove the Right Side Shield
(8). Remove the two M4 x 16mm Screws (63) and the
M4 x 38mm Screw (66) from the Right Side Shield.
Next, remove the Screws (63, 66 [not shown]) from
the Left Side Shield (7). Using an adjustable wrench,
turn the Right Pedal (17) counterclockwise and
remove it. Rotate the Right Crank Arm (23) so that it
is pointing toward the front of the exercise cycle, and
slide off the Right Side Shield.
Next, locate the Reed Switch (64). Turn the Right
Crank Arm (23) until the Magnet (46) is aligned with
the Reed Switch. Loosen, but do not remove, the indi-
cated M4 x 16mm Screw (63). Slide the Reed Switch
slightly closer to or away from the Magnet. Then,
retighten the Screw. Turn the Right Crank Arm for a
moment. Repeat until the console displays correct
feedback. When the Reed Switch is correctly adjust-
ed, reattach the right side shield and the right pedal.
HOW TO ADJUST THE DRIVE BELT
If you can feel the pedals slip while you are pedaling,
even when the resistance is adjusted to the highest
level, the Drive Belt (20) may need to be adjusted. To
adjust the Drive Belt, you must first remove the right
side shield. Refer to HOW TO ADJUST THE REED
SWITCH at the left and remove the right side shield.
Next, turn the indicated M8 Nylon Locknut (60) until
the Drive Belt (20) is properly tightened. Then, reat-
tach the right side shield.
PULSE SENSOR TROUBLESHOOTING
• Avoid moving your hands while using the pulse sen-
sor. Excessive movement may interfere with heart
rate readings. Do not hold the metal contacts too
tightly; doing so may interfere with heart rate read-
ings.
• For the most accurate heart rate reading, hold the
metal contacts for about 15 seconds.
• For optimal performance of the pulse sensor, keep
the metal contacts clean. The contacts can be
cleaned with a soft cloth—never use alcohol,
abrasives, or chemicals.
MAINTENANCE AND TROUBLESHOOTING
66
63
63
60
23
17
7
8
64
23
63
46
20