Filter
Top Products
20
If the speed or incline settings are too high or too
low, you can manually override the settings at any
time by pressing the Speed or Incline buttons on
the console. However, when the next ÒchirpÓ is
heard, the speed and/or incline will change to
the next settings of the CD or video program.
To stop the walking belt at any time, press either
of the Stop buttons on the console. The Time/
Segment Time display will begin to flash. To
restart the program, press the Start button or the
Speed
▲▲
button. After a moment, the walking belt
will begin to move at 1.0 mph. When the next
ÒchirpÓ is heard, the speed and incline will
change to the next settings of the CD or video
program. The program can also be stopped by
pressing the Stop button on your CD player or
VCR.
When the CD or video program is completed, the
walking belt will stop and the Time/Segment Time
display will begin to flash. Note: To use another
CD or video program, press a Stop button or re-
move the key and go to step 1 on page 19.
Note: If the speed or incline of the treadmill
does not change when a ÒchirpÓ is heard:
¥ make sure that the IFit.com indicator is lit and
that the Time/Segment Time display is not
flashing. If the Time/Segment Time display is
flashing, press the Start button or the Speed
▲▲
button on the console
¥ adjust the volume of your CD player or VCR. If
the volume is too high or too low, the console
may not detect the program signals
¥ make sure that the audio cable is properly
connected, that it is fully plugged in, and that
it is not wrapped around a power cord
¥ if you are using your portable CD player and
the CD skips, set the CD player on the floor or
another flat surface instead of on the console.
Follow your progress with the four displays.
See step 6 on page 11.
When the program is completed, remove the
key.
Step onto the foot rails and make sure that the in-
cline of the treadmill is at 0%. The incline must
be at 0% when the treadmill is raised to the
storage position. Next, remove the key from the
console and put it in a secure place. Note: If the
displays and indicators on the console remain
lit after the key is removed, the console is in
the ÒdemoÓ mode. Refer to page 22 and turn off
the demo mode.
When you are finished using the treadmill, move
the on/off switch near the power cord to the off
position and unplug the power cord.
6
5