8
HOW TO USE THE ELLIPTICAL CROSSTRAINER
PLUGGING IN THE POWER CORD
Plug the power
cord into a 120-volt
outlet. The displays
and indicators on
the console will
flash once; the dis-
plays and various
indicators will then
light and a tone will
sound. Please
read through all instructions in this section before
using the elliptical crosstrainer.
EXERCISING ON THE ELLIPTICAL CROSSTRAINER
To mount the elliptical crosstrainer, hold the handlebar
and step onto the pedal that is in the lowest position.
Next, step onto the other pedal. Push the pedals until
they begin to move with a continuous motion. Note:
The pedal disks can turn in either direction. It is
recommended that you move the pedals disks in
the direction shown below; however, to give vari-
ety to your exercise, you may choose to turn the
pedal disks in the opposite direction.
To dismount the elliptical crosstrainer, wait until the
pedals come to a complete stop. CAUTION: The
elliptical crosstrainer does not have a freewheel;
the pedals will continue to move until the flywheel
stops. When the pedals are stationary, step off the
highest pedal first. Then, step off the lowest pedal.
INCLINE ADJUSTMENT
The incline frame can be raised or lowered to vary the
intensity of your exercise. To raise the incline frame,
lift the end of the incline frame until the crossbar is
resting on top of the incline bracket. Make sure that
the incline frame is resting securely on top of the
incline bracket. To lower the incline frame, first lift
the incline frame slightly. Then, push the incline brack-
et toward the upright and lower the incline frame onto
the stabilizer.
USING THE UPPER BODY ARMS
The upper body arms are designed to give you a total
body workout. As you exercise, hold the upper body
arms and move your arms forward and back in order
to work your arms, back, and shoulders.
If you want to exercise only your lower body, hold the
handlebar as you exercise.
Pedal
Pedal Disk
Upper
Body
Arms
Incline Frame
Incline
Bracket
Stabilizer
Crossbar
Upright
Handlebar