Filter
Top Products
5
1. Make sure that there are Stabilizer Endcaps (27) on
the ends of both Stabilizers (30).
Hold one of the Stabilizers (30) against the saddle on
the front of the Base (1). Make sure that the Stabilizer
is turned so the square holes are facing away from the
Base. Attach the Stabilizer with two 3/8Ó x 3 1/2Ó
Carriage Bolts (28) and two 3/8Ó Nylon Locknuts (29).
2. Hold the other Stabilizer (30) against the saddle on the
rear of the Base (1). Make sure that the Stabilizer is
turned so the square holes are facing away from the
Base. Attach the Stabilizer with two 3/8Ó x 3 1/2Ó
Carriage Bolts (28) and two 3/8Ó Nylon Locknuts (29).
3. Refer to the inset drawing. Feed the console wire har-
ness into the Upright (3), until the end of the console
wire harness extends from the bottom of the Upright.
While another person holds the Upright (3), connect
the console wire harness to the Main Wire Harness
(39). If the wire harnesses do not fit together easily,
turn themÑdo not force them together. After you
have connected the wire harnesses, pull any slack
in the wire harnesses up through the Upright.
Slide the Upright (3) onto the welded bolts on the Base
(1). Be careful to avoid pinching the wire harnesses.
Tighten a 3/8Ó Nylon Locknut (29) onto each welded bolt.
1
27
1
30
29
28
27
2
1
30
29
28
3
Console
Wire
Harness
29
29
3
1
39
3
Console
Wire
Harness
4. Attach the Handlebar (9) to the bracket on the
Upright (3) with two 1/4Ó x 1/2Ó Bolts (71) and two
1/4Ó Nylon Jam Nuts (78).
78
9
3
71
4