Filter
Top Products
4
3/8" Nylon Locknut (29)Ñ8
1/4" Nylon Jam Nut (78)Ñ2
3/8Ó Zinc Washer (52)Ñ2
3/8Ó Lock Washer (58)Ñ2
3/8" x 1Ó Screw (59)Ñ2
Plastic Spacer (56)Ñ4
1/4" x 1/2Ó Bolt (71)Ñ2
5/8Ó Axle Cap (50)Ñ2*
3/4Ó Axle Cap (43)Ñ2*
Pedal Arm Spacer (41)Ñ2
3/8" x 3 1/2Ó Carriage Bolt (28)Ñ4
#8 x 3/4Ó Black Screw (44)Ñ10
ASSEMBLY
Assembly requires two persons. Place all parts of the elliptical crosstrainer in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed.
The following tools are required for assembly: a phillips screwdriver , two adjustable
wrenches , and a rubber mallet .
PART CHART
Use the part drawings below to identify the small parts used in assembly. The number in parenthesis below each
drawing refers to the key number of the part. The second number refers to the quantity used in assembly. Note:
Some small parts may have been pre-attached for shipping. If a part is not in the parts bag, check to see
if it has been pre-attached.
*Extra Axle Caps (43, 50) may be included.