Filter
Top Products
6
3
8
5
6
41
41
Tab
Slot
Hole
28
1
7
31
5. Orient the Handlebar (7) as shown. Next, slide the
Handlebar Sleeve (31) downward until the tab on
the Handlebar Sleeve is covering the indicated hole
in the Handlebar.
Loosen and remove the Handlebar Knob (28). Next,
press the tab on the Handlebar Sleeve (31) and
insert the Handlebar (7) and the Handlebar Sleeve
into the Frame (1); make sure that the tab on the
Handlebar Sleeve is in the indicated slot in the
Frame. Then, slide the Handlebar upward or down-
ward to the desired height, and tighten the
Handlebar Knob into the Frame and an adjustment
hole in the Handlebar. Make sure that the
Handlebar Knob is engaged in an adjustment
hole in the Handlebar.
6. Orient the Seat (8) and the Seat Carriage (3) as
shown. Attach the Seat to the Seat Carriage with
four M6 x 16mm Screws (41). Note: The Screws
may be preattached to the underside of the Seat.
4. Orient the Pedal Frame (5) as shown, and then
insert the Pedal Frame into the Pivot Frame (6).
Attach the Pedal Frame with two M10 x 15mm
Button Screws (48), two M10 Spring Washers (57),
and two M10 Washers (58).
4
6
48
57
5
58