Filter
Top Products
6
1. Attach the Rear Stabilizer (4) to the Frame (1) with
two M10 x 105mm Carriage Bolts (34) and two M10
N
ylon Locknuts (29).
2. Hold the Lower Wire Harness (65) in the indicated
slot in the Frame (1), and insert the Front Stabilizer (3)
into the Frame. Make sure that the Front Stabilizer
is oriented as shown. Be careful to avoid pinching
the Lower W
ire Harness. Carefully tip the elliptical
exerciser onto one side, and attach the
Front
Stabilizer with four M10 x 22mm Button Screws (21)
and four M10 Split Washers (67).
2
1
34
4
1
29
29
21
3
65
67
67
Slot
1
3. While another person holds the Upright (2) near the
Frame (1), connect the Upper Wire Harness (79) to
the Lower Wire Harness (65). Carefully pull the
upper end of the Upper Wire Harness to remove
any slack, and set the Upright on the Front Stabilizer
(3) and the Frame. Be careful to avoid pinching the
Wire Harnesses. Align the holes in the Upright with
the holes in the Front Stabilizer and the Frame.
Carefully tip the elliptical exerciser onto one side, and
attach the Upright (2) to the Front Stabilizer (3) and
the Frame (1) with four M10 x 58mm Button Screws
(19) and four M10 Split Washers (67).
2
65
67
79
1
3
3
19
81
30
1
2
67
4. Gently separate the Left and Right Frame Covers (30,
81). Hold the Frame Covers around the Upright (2)
and the Frame (1). Firmly press the Frame Covers
together.
4