Filter
Top Products
6
31
Sticker
26
3
48
71
Console
Wire
Harness
6
6
6. Attach the Console Plate (31) to the Upright (3) with
two 1/4Ó Bolts (71) and two 1/4Ó Nylon Jam Nuts (48).
Make sure that the Console Plate is turned so the
sticker is on the side shown.
Feed all of the slack in the console wire harness down
into the Upright (3). Attach the Console (6) to the
Console Plate (31) with four Zinc Screws (26). Be
careful to avoid pinching the console wire harness.
5. Hold the Left Handlebar (8) against the left side of the
Upright (3) as shown. Set the Saddle Bracket (72) on
top of the Left Handlebar. Insert a 3/8Ó Bolt (50) down
through the Saddle Bracket, the Left Handlebar, and
the Upright. Thread a 3/8Ó Nylon Locknut (29) onto the
Bolt. Do not tighten the Nylon Locknut yet. Insert a
1/4Ó Carriage Bolt (64) through the lower end of the
Left Handlebar and the tab on the front of the Upright.
Hold the Right Handlebar (9) against the right side of
the Upright (3). Insert a 3/8Ó Bolt (50) down through
the Saddle Bracket (72), the Right Handlebar, and the
Upright. Thread a 3/8Ó Nylon Locknut (29) onto the
Bolt. Do not tighten the Nylon Locknut yet.
Thread a 1/4Ó Nylon Jam Nut (48) onto the 1/4Ó Carriage
Bolt (64). Tighten all parts used in this step.
5
8
9
3
64
48
29
50
72
4. Refer to the inset drawing. Remove the 3/8Ó Bolt (50)
and the 3/8Ó Nylon Locknut (29) from the lower end of
each Upper Body Arm (10, 11). The Bolts and Nylon
Locknuts will be used in assembly step 5.
Apply a thin film of grease to both Upper Body Arms
(10, 11) in the indicated locations.
Hold the lower end of the Left Upper Body Arm (10)
inside the bracket on the Upright (3). Insert the Long
Carriage Bolt (66) into the bracket and through the
Left Upper Body Arm. Note: When inserting the
Long Carriage Bolt, be careful to avoid damaging
the console wire harness inside the Upright.
Hold the Right Upper Body Arm (11) inside the bracket
on the Upright (3). Insert the Long Carriage Bolt (66)
through the Right Upper Body Arm. Make sure that the
head of the Carriage Bolt is in the square hole in the
bracket. Slide the 3/8Ó Star Washer (68) onto the Long
Carriage Bolt. Tighten the Arm Resistance Knob (69)
onto the Long Carriage Bolt.
11
Grease
Grease
69
68
3
66
10
4
50
10
29