Filter
Top Products
10
CABLE ASSEMBLY
17
21
15
59
15
66
9
9
Bracket
17
16
16. Attach the Long Cable (58) to the Weight
Carriage (19) with a 3/8” x 3/4” Bolt (69) and
a 3/8” Nylon Locknut (21). Make sure that
the Bolt and the Nylon Locknut are tight.
17. Using a 3/8” x 3 1/2” Bolt (16), a 3/8” Flat
Washer (9), and a 3/8” Nylon Locknut (21),
secure a 3 1/2” Pulley (15) and a Cable Trap
(66) to the upper hole in the Press Frame
(17). Make sure that the Cable Trap and the
Pulley are oriented as shown.
Hold a 3 1/2” Pulley (15) inside the indicated
bracket on the Press Frame (17). Using a 3/8”
x 8” Bolt (59), two 3/8” Flat Washers (9), and
a 3/8” Nylon Locknut, attach the 3 1/2” Pulley
to the Press Frame as shown.
18. Locate the Short Cable (23). Route the
Short Cable under the indicated 3 1/2” Pulley
(15). Be sure that the end of the Cable with
the ball is between the Pulley and the
crossbar on the Press Frame (17).
23
Crossbar
Ball
15
17
18
16
19
21
69
58