Filter
Top Products
7
7. Attach the Backrest (14) to the Backrest Frames
(10) with four M6 x 38mm Bolts (46) and four M6
Washers (45). Do not tighten the Bolts yet.
8. Lubricate the M10 x 156mm Bolt (39) with
grease. Attach the Backrest Frames (10) to the
Bench Frame (1) with the Bolt, two M10 Washers
(49), and an M10 Nylon Locknut (37). Do not
overtighten the Locknut; the Backrest Frames
must be able to pivot easily.
Insert the Adjustment Bracket (11) into the slot in
the Bench Frame (1). Insert the Backrest Pin (38)
into the Bench Frame and a hole in the
Adjustment Bracket.
Attach the tether on the Backrest Pin (38) to the
bottom of the Bench Frame (1) with an M4 x
16mm Screw (53).
Tighten the four M10 Nylon Locknuts (37) and
four M6 x 38mm Bolts (46) used in steps 6 and
7.
6. Press four 25mm Square Inner Caps (28) into the
ends of the Backrest Frames (10).
Attach the Backrest Frames (10) to the
Adjustment Bracket (11) with four M10 x 45mm
Bolts (43), four M10 Washers (49), and four M10
Nylon Locknuts (37). Make sure the indicated
holes are closer to the bottom of the Frames.
Do not tighten the Locknuts yet.
5. Press three 45mm Square Inner Caps (26) into
the Leg Lever (6). Press a 25mm Round Inner
Cap (47) into the Weight Tube (15).
Attach the Weight Tube (15) to the Leg Lever (6)
with an M8 x 58mm Bolt (33), two M8 Washers
(34), a Spacer (29), and an M8 Nylon Locknut
(35). Press the 25mm Round Angled Cap (25)
onto the end of the Weight Tube.
Lubricate an M10 x 68mm Bolt (41) with grease.
Attach the Leg Lever (6) to the Front Leg (4) with
the Bolt and an M10 Nylon Locknut (37). Do not
overtighten the Locknut; the Leg Lever must
be able to pivot easily.
5
26
26
6
4
33
34
26
15
47
37
41,
Lubricate
6
43
28
37
28
28
37
43
11
49
49
49
Hole
Hole
49
10
7
14
10
45
46
46
45
45
8
10
1
39
49
49
37
53
38
11
29
25
35
34