Filter
Top Products
6
2. Press two Base Feet (18) onto a Base (3) as
shown.
Attach a Support Upright (7) to the Base (3) with
two M8 x 50mm Bolts (48), two M8 Washers (34),
and two M8 Nylon Locknuts (35). Do not tighten
the Locknuts yet.
Assemble the other Base (3) and Support
Upright (7) in the same manner.
Set the Uprights (8) on the Bases (3) as shown.
Attach an Upright to a Base with two M10 x
95mm Bolts (40), an Upright Joint Plate (19), and
two M10 Nylon Locknuts (37). Attach the other
Upright and Base in the same manner. Do not
tighten the Locknuts yet.
Attach an Upright (8) to a Support Upright (7) with
four M10 x 95mm Bolts (40), two Upright Support
Plates (20), and four M10 Nylon Locknuts (37).
Do not tighten the Locknuts yet.
Attach the other Upright (8) to the other
Support Upright (7) in the same manner.
3. Press a 50mm Square Inner Cap (27) into the top
of the Front Leg (4). Press the Front Leg Foot
(17) onto the bottom of the Front Leg, as shown.
Attach the Front Leg (4) to the Bench Frame (1)
with four M10 x 68mm Bolts (41), two Front Leg
Plates (21), and four M10 Nylon Locknuts (37).
Do not tighten the Locknuts yet.
4. Attach the Bench Frame (1) to the Crossbar (2)
with two M10 x 95mm Bolts (40) and two M10
Nylon Locknuts (37).
Tighten M10 Nylon Locknuts (37) and M8
Nylon Locknuts (35) used in steps 1–4.
2
3
4
8
8
7
20
20
7
40
37
18
34
18
Tall
Side
Tall
Side
Tall
Side
37
1
41
21
4
27
17
40
1
37
2
18
40
3
3
35
48
19
37
37
48