Filter
Top Products
13
15. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of clear
plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the tread-
mill. Note: Extra hardware may be included. Keep the included hex keys in a secure place; one of the hex
keys is used to adjust the walking belt (see pages 23 and 24).
51
Large
Barrel
60
8
53
3
50
14
11
49
14. Raise the Frame (53) to the position shown.
Have a second person hold the Frame until
this step is completed.
Orient the Storage Latch (50) so that the large
b
arrel and the Latch Knob (51) are in the posi-
tions shown.
Remove the tie from the upper end of the
Storage Latch (50). Attach the upper end of the
Storage Latch to the bracket on the Frame (53)
with a 3/8" x 2" Bolt (3) and a 3/8" Locknut (11).
Remove the tie from the lower end of the
Storage Latch (50). Keep the holes in the Latch
Cap (49) aligned with the holes in the Storage
Latch. Make sure to keep the Latch Cap in-
side the Storage Latch. Attach the Storage
Latch to the bracket on the Base (60) with a 3/8"
x 1 3/4" Bolt (8). Note: It may be necessary to
move the Frame (53) back and forth to align the
Storage Latch with the bracket.
Lower the Frame (53) (see HOW TO LOWER
THE TREADMILL FOR USE on page 21).
If you purchase the optional chest pulse sensor (see page 20), follow the steps below to install the re-
ceiver included with the chest pulse sensor.
16. Make sure that the power cord is unplugged.
Remove the indicated #8 x 3/4" Screw (1) and
the Access Door (102) from the Console Base
(96).
17. Connect the wire on the receiver (A) to the indi-
cated wire extending from the Console Base
(96). Hold the receiver so that the antenna is
oriented as shown and is facing the Console
Base. Attach the receiver to the plastic posts on
the Access Door (102) with the two included
small screws.
18. Make sure that no wires are pinched.
Reattach the Access Door (102) with the #8 x
3/4" Screw (1). Discard the other wires included
with the receiver.
A
102
Antenna
1
96
Wire
Small
Screws