Filter
Top Products
10
8. Insert the end of a Crosswalk Arm (98) into the
hole in the top of a resistance mechanism.
Make sure that the bend in the Crosswalk
Arm is positioned as shown.
Tighten a #8 x 3/4" Screw (1) into the resistance
mechanism and the Crosswalk Arm (98) from
the direction shown. Then, press a Small Cap
(34) into the hole for the Screw.
Attach the other Crosswalk Arm (98) as de-
scribed above.
Carefully lower the Crosswalk Arms (98) down
towards the Walking Belt (42).
7. Remove the Resistance Knob (110) from a re-
sistance mechanism. Make sure that the 3/8" x
4
3/4" Bolt (112) stays inside the resistance
mechanism and that the resistance mecha-
nism does not come apart. Note: See the
lower drawing to reassemble the resistance
mechanism if necessary.
Apply a small amount of the included grease
around the Resistance Cone (108) and the
Upright Insert (111).
Insert the Resistance Cone (108) into the
Upright Insert (111) in the Left Upright (77), with
the two large holes on top as shown. Then,
tighten the Resistance Knob (110) onto the 3/8"
x 4 3/4" Bolt (112). Do not fully tighten the
Resistance Knob.
Attach the other resistance mechanism to
the Right Upright (79) as described above.
110
Large
Holes
Resistance
Mechanism
112
110
111
79
Large
H
oles
108
112
7
7
7
98
1
1
Hole
34
98
34
Resistance
Mechanism
Resistance
Mechanism
8
Bend
42