Filter
Top Products
8
6. Attach the Support Frame (15) to the Upright
Base (3) with an M10 x 62mm Bolt (24) and an
M
10 Nylon Locknut (44). D
o not tighten the
Locknuts yet.
Attach the Support Frame (15) and the Left and
Right Legs (6, 7) to the Backrest Frame (8) with
four M10 x 53mm Bolts (30) and four M10 Nylon
Locknuts (44).
Tighten the M10 Nylon Locknuts (44) and M8 x
15mm Screws (49) used in steps 2–6.
7. Attach a Pull-up Handle (13) inside the Top
Frame (5) with four M8 x 19mm Screws (38) and
four M8 Curved Washers (39).
Slide a 51mm Round Outer Cap (23) onto the
Pull-up Handle (13) and press the Cap into the
Top Frame (5).
Repeat this step on the other side of the Top
Frame (5).
8
6
7
7
15
44
44
44
24
30
30
6
3
39
39
38
38
38
38
23
5
13
8.
Attach the Pad Frame (10) to the Pivot Arm (9)
with two M8 x 19mm Screws (38), two M8
Washers (37), and two 5mm Spacers (34).
10
34
34
37
38
9
8
37
38