Filter
Top Products
7
5. Attach the Bench Frame (1) to the Crossbar (3)
with two M8 x 81mm Button Bolts (47), a Support
Plate (60), and two M8 Nylon Locknuts (58).
T
ighten the M8 Nylon Locknuts (58) used in
steps 1–5. Do not overtighten the Locknuts
used in step 4; overtightening may make it dif-
ficult to raise and lower the Weight Rests (not
shown).
7. Attach the Backrest (13) to the Backrest Frames
(10) with four M6 x 38mm Screws (51) and four
M6 Washers (33). Do not tighten the Screws
yet.
6. Orient the two Backrest Frames (10) as shown.
Make sure the indicated holes are closer to
the bottom. Attach the Backrest Frames to the
Adjustment Bracket (9) with four M8 x 42mm
Button Bolts (50), four M8 Washers (53), and four
M8 Nylon Locknuts (58).
Do not tighten the
Locknuts yet.
1
58
58
3
60
47
5
10
9
58
58
Hole
Hole
50
50
53
53
53
6
13
10
51
7
51
33
33
10