Filter
Top Products
11
5
32
14
Bracket
43
6
7
43
8
8
ADJUSTING THE WEIGHT RESTS
To change the height of a Weight Rest (8), first
remove the Upright Pin (43) from the Upright (6 or 7).
Then, hold the Weight Rest at the desired height.
Finally, fully tighten the Upright Pin into the Upright
and the Weight Rest.
WARNING: Always set both Weight
Rests (8) at the same height.
ATTACHING THE CURL BAR
Pull the indicated Short Pin (32) out of the Leg Lever
(5). Hold the Curl Bar (14) inside the Leg Lever
bracket, and insert the Short Pin through the Leg
Lever and the Curl Bar.