Filter
Top Products
6
2. Attach the Bench Frame (1) to the Front Leg (4)
with two M8 x 81mm Button Bolts (47), a Support
Plate (60), and two M8 Nylon Locknuts (58).
Do
not tighten the Locknuts yet.
4.
Orient the Crossbar (3) so the “GB 1500” decal is
in the position shown.
Attach the Crossbar to the
Right Upright (7) with two M8 x 92mm Button
Bolts (57), a Long Support Plate (65), and two M8
Nylon Locknuts (58).
Do not tighten the
Locknuts yet.
Repeat this step with the Left Upright (6).
3. Press a Rear Base Cap (21) and a Front Base
Cap (22) onto the Left Upright (6) as shown.
Remove the Upright Pin (43) from the Left Upright
(6). Rotate the Weight Rest (8) to the position
shown. Fully tighten the Upright Pin into the
Upright and the Weight Rest.
Repeat this step with the Right Upright (not
shown). Make sure both Weight Rests (8) are
set to the same height.
Note the position of the decal to identify the
Left Upright (6).
47
47
4
60
58
1
2
43
3
6
3
57
57
65
58
7
4
6
8
22
21
Decal
Decal