Filter
Top Products
23
|
GARY FISHER SERVICE INFORMATION
These instructions and parts are for the aluminum FSA cranks only. The current “B” kit
will not work for FSA carbon cranks.
The Cronus uses a special bearing system that has no parts that thread into the frame.
Instead, the bearings are a slip-t into the frame (Figure 47). This section explains how
to install the bearings and crankset.
The bearings might t into the frame tightly. In this case, you might need to tap them
with a soft-faced mallet. However, do not use a hammer or bearing press to install the
bearings into the frame. If the bearing t is too tight, make sure the bearings are clean
and free of debris.
Tools and materials required
To complete the installation, you will also need the FSA instructions, available at:
http://www.road.fullspeedahead.com/downloady.aspx?download=downloads/
Install_MegaExoAlloy.pdf.
+ Crankset and bearings (bearing shields come pressed onto the bearings)
+ 5 mm Allen Wrench
+ Rock “N” Roll Super Coat grease
+ Bottom bracket parts
Part description FSA
BB90 bearing kit “B” 293227
Drive side parts
Bearing 300162
Seal 294668
Non-drive side
parts
Bearing 300162
Seal 294668