Filter
Top Products
10
|
GARY FISHER SERVICE INFORMATION
Fender Installation
This section explains how to install front and rear fenders on a Cronus using the
accessory dropout adapters and custom brake attachment nuts. Each dropout adapter,
or “eyelet,” is a special screw with an eyelet. The brake attachment nut includes a bolt
that threads into the nut.
Description Part number
Custom dropout eyelet w/locknut, set of four
Eyelet (2) 295468
Locknut (2) 300381
Custom brake nut w/inside screw, set of two
Nut (FT) 297424
Nut (RR) 297728
Installing the eyelets
1. With a 25mm hex, remove the plugs that cover the threaded holes in the rear dropouts
and fork tips (Figure 12).
2. Thread a locknut onto each eyelet, and thread the eyelet into the dropout (Figure 13).
3. Align the eyelet and secure its position by tightening the locknut.
Attaching the bridge clips
1. Loosen and remove the interior screw from the brake nut (Figure 14).
2. Position the bridge clip and place the interior screw through the attachment hole
(Figure 15), but do not tighten.
Continued next page