Filter
Top Products
Fisher-Price
®
• Align the lever on the side of the collar with the
opening in the top of the lower post.
• Fit the collar onto the lower post, making sure the peg
on each side of the collar snaps into the hole on each
side of the post.
Collar
4
5
6
Lower Post
Rib
Groove
Base
Lever
Opening
Lower
Post
Hole
Peg
• If the lever comes off, simply re-attach it.
• Insert the peg on one side of the lever into the hole in
the collar.
• Snap the other peg in the lever into the other hole in
the collar.
Assembly is now complete.
Please refer to assembly step 6 to fill the base with
water or approximately 50 lbs. of sand (water and sand
not included) to keep this product stationary.
Holes
Peg
Peg
• Move to the side of the assembly.
• Place your foot on the base to hold it steady.
• Press down firmly on the lower backboard while
rotating the backboard up.
• When properly assembled, the pegs on the upper post
rest in the grooves in the backboard, as shown.
Assembly
13
14
15
16
Top View
PULL HERE
PRESS HERE
Peg
Peg
Grooves
Back View
• Align the rib on the bottom of the lower post with the
groove in the opening in the base.
• Insert the lower post into the opening and push down,
using a circular motion, until it snaps into place.
Note: The height of the rim is three feet as assembled.
Note: The collar may already be factory assembled.
IMPORTANT! Assembly of the lower post is a per-
manent assembly.
Hint: For easier assembly, apply a small amount of
liquid soap around the bottom of the post. If assem-
bling inside, place a tarp under the base to protect
the floor surface.
6
72408c-0920.qrk 5/2/02 4:44 PM Page 6