Filter
Top Products
• Slide a wheel to each end of the axle.
• Turn the base upside down.
• Fit the axle into the groove in the base.
• Press down firmly on the wheels to snap the axle into
the groove.
• Pull up on the wheels to be sure that the axle is
secure. If you can remove the axle from the groove,
re-read and repeat this step.
• Place the loops at the top of the net into the grooves
on the ring.
• Pull each loop through a ring tab, as shown.
Groove
Ring
Ring Tab
• Place the rim on a flat surface with the rectangular
tabs facing up.
• Locate the four screw holes on the underside of the
net assembly.
• Align the four screw holes on the underside of the net
assembly with the four holes in the rim.
• Place the net assembly onto the rim.
• Turn the base right side up.
• Bend the “T” end of the plug and insert it into the hole
in the base.
Plug
“T” End
Axle
Base
Groove
Base
Groove
Ring
Tab
Hole
Hole
Rectangular
Tabs
Hole
Rim
Hole
Net Assembly
Bottom View
Press
Here
Press
Here
Assembly
5
6
8
7
4
Note: After assembly is complete, fill the base with
water or approximately 50 lbs. of sand (water and
sand not included) to keep this product stationary.
Simply lift the plug, fill the base, and replace the plug.
72408c-0920.qrk 5/2/02 4:44 PM Page 4