Filter
Top Products
Axle
Cap Nut
Side Edge
Block of
Wood
• Place a cap nut on a scrap block of wood.
• Place one end of the axle into the cap nut.
• Tap the other end of the axle with a hammer. Make
sure the cap nut is securely attached to the axle.
Proper label application will help to keep the label
looking its best!
• Wash your hands before applying the label.
• Make sure the area where the label will be applied is
clean and dry. Wipe the backboard with a clean, soft,
dry cloth to remove any dust or oils.
• For best results, avoid applying the label more
than once.
• Peel the backing from one half of the label. Do not
remove all of the backing!
• Align the side edge of the label (where backing is
removed) with the side edge of the label area on
the backboard.
• Carefully apply the side edge of the label to the side
edge of the label area on the backboard.
• While rubbing the label in place, continue to peel the
backing from the other half of the label.
• After applying the label, rub the label firmly with a cloth
to make sure the label is adhered to the backboard.
• Dispose of the label backing properly.
• Slide a wheel, recessed side down, onto the axle.
• Slide the other wheel, recessed side up, onto the axle.
Recessed Side
of Wheel
Axle
Recessed Side
of Wheel
• Place the other cap nut on the other end of the axle.
• Tap the cap nut with the hammer. Make sure the cap
nut is securely attached to the axle.
Axle
Cap Nut
Backboard
This package contains small parts in its
unassembled state.
Adult assembly is required.
CAUTION
Assembly
3
1
2
4
3
72408c-0920.qrk 5/2/02 4:44 PM Page 3