Filter
Top Products
16
Gain Setting for Analog Audio Input
You can adjust the relative volume between the LINE IN
terminals. Once the relative volume is set, each component
connected to the AZ-1 will have the approximate same volume
level.
Select an input to be changed (LINE1, LINE2 or
LINE3/PHONO) by turning the INPUT knob.
Start with the component that has the lowest volume level.
Press and hold the SETUP button for more than 2
seconds.
The unit enters setup mode, and “GainL
*
>
***
” appears on
the display. (
***
changes depending on your setting.)
If you leave the unit idle for 10 seconds, the setup mode will
be cancelled.
Turn the INPUT knob to change the Gain setting.
Adjustable range: 0, +3, +6, +9, +12, +15, +18, +21, +24
3
2
1
Press and hold the SETUP button for more than 2
seconds (or leave the unit idle for 10 seconds) to exit
the Gain setup mode.
<
Settings are stored even when power is turned off and the
unit is unplugged. If left unplugged for an extended period,
the settings may be lost.
<
If you lightly press the SETUP button, the unit enters name
and skip setting mode. See page 17 for details.
4
SETUPINPUT