Filter
Top Products
12
43 2
standby indicator
First of all, turn on the power of the connected
components.
1
It may take several seconds for the unit to start outputting
sounds. Wait until “WAIT ...” disappears from the display.
Select an input by turning the INPUT knob.
3
The current input appears on the left of the display.
Repeatedly turn the knob until the desired input appears on
the display.
COAX1, COAX2, OPT1, OPT2, LINE1, LINE2,
LINE3 or PHONO*, i.LINK
*: PHONO appears only when the LINE/PHONO switch is set to
PHONO.
<
When you select a digital terminal, “the sampling frequency
of an incoming digital signal” or “DSD” appears on the right
of the display.
<
i.LINK indicator blinks when the unit cannot recognize the
digital signal. In that case, connect a digital device to the
i.LINK(AUDIO) terminal and switch it on.
Play the source, and gradually turn up the volume to
the required level by turning the VOLUME knob.
4
Basic Operation
To turn the unit off (standby)
To prevent sudden noise from the speakers, make sure to turn
the unit off in the following way.
1. Stop the playback of the connected component.
2. Turn the AZ-1 standby using the STANDBY button.
3. Turn the connected components off.
Press the STANDBY button to turn the unit on.
The indicator is red in the standby mode. It turns blue when
the unit is turned on.
2