Filter
Top Products
6
ASSEMBLY
T
o hire an authorized service technician to assemble the treadmill, call 1-800-445-2480. Assembly re-
quires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of
the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated
with high-performance lubricant. During shipping, some lubricant may be transferred to the top of the walking belt
o
r the shipping carton. This is normal and does not affect treadmill performance. If there is lubricant on top of the
walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.
Assembly requires the included hex keys and your own Phillips screwdriver and
adjustable wrench .
For help identifying the assembly hardware, see the drawings below. The number in parentheses below each
drawing is the key number of the part, from the PART LIST near the end of this manual. The number following the
parentheses is the quantity needed for assembly. Note: Some small parts may have been preassembled. To
avoid damaging parts, do not use power tools for assembly. Extra hardware may be included.
3/8" Star
Washer (8)–8
#8 x 3/4" Screw
(7)–9
3/8" Nut (9)–2
3/8" x 1 1/4" Patch Bolt (1)–4
3/8" x 3 3/4" Patch Bolt (2)–4
1/4" x 1 1/4" Bolt (4)–2
1/4" x 1 3/4" Bolt (3)–2
3/8" x 1 3/4" Bolt (5)–1
3/8" x 2" Bolt (6)–1
1. Make sure that the power cord is unplugged.
Locate two cardboard stands. With the help of a
second person, raise the front of the treadmill
and insert the crossbar on the Base (115) into
the cutouts in the cardboard stands as shown.
Make sure the cardboard stands are far
enough apart to support the treadmill.
Serious injury may occur if the treadmill
moves forward or backward and falls off the
cardboard stands. A second person must
hold the treadmill until assembly step 3 is
completed to prevent the treadmill from
moving, tipping, or falling.
115
Cardboard
Stands
1