Filter
Top Products
12
1. Make sure that the power cord is unplugged.
Remove the indicated #8 x 3/4" Screws (7) from
the Pulse Receiver Cover (95) on the back of the
console assembly.
2. Next, hold the receiver so that the antenna is
oriented as shown. Peel the paper backing off
the pad on the bottom of the receiver. Press the
receiver onto the Receiver Cover (95) in the lo-
cation shown.
3. Connect the wire on the receiver to the wire ex-
tending from the console assembly. Make sure
that no wires are pinched. Reattach the Pulse
Receiver Cover (95) to the console assembly
with the two #8 x 3/4" Screws (7). Discard the
other wires included with the receiver.
If you purchase the optional chest pulse sensor (see page 23), follow the steps below to install the re-
ceiver included with the chest pulse sensor.
Console
Assembly
1
95
7
3
95
Wires
7
95
Antenna
2
Receiver
Console
Assembly
Receiver