Filter
Top Products
9
5. With the help of a second person, hold the con-
sole assembly (E) near the Upright (96).
Connect the Upright Wire (92) to the console
wire. See the inset drawing. The connectors
should slide together easily and snap into
place. If they do not, turn one connector and try
again. IF YOU DO NOT CONNECT THE CON-
NECTORS PROPERLY, THE CONSOLE MAY
BECOME DAMAGED WHEN YOU TURN ON
THE POWER.
Then, connect the pulse wires (F). Make sure to
connect the pulse wires on the right side (not
shown) also.
E
96
5
F
92
92
Console
Wire
1
E
F
6
6
4
C
D
E
C
6. With the help of a second person, hold the
console assembly (E) near the left handrail
assembly (C). Raise the console assembly
enough to position the wires (F) so that they will
not get pinched as you set the console assembly
on the left handrail assembly. Be careful not to
pinch any wires.
See the inset drawing. Make sure that the con-
sole assembly (E) is flush against the handrail
assemblies (C, D) in the locations shown by the
arrows.
Attach the console assembly (E) to the handrail
assemblies (C, D) with four 5/16" x 3/4" Screws
(1), four 5/16" Flat Washers (6), and four 3/8"
External Star Washers (4) as shown (only one
side is shown). Start all four Screws and then
tighten them.