Filter
Top Products
7
9. Make sure that all parts are properly tightened before you use the exercise cycle. Note: After assembly is
completed, some extra parts may be left over. Place a mat beneath the exercise cycle to protect the floor.
8. Identify the Left Pedal (22), which is marked with an
“L.” Using an adjustable wrench, firmly tighten the
L
eft Pedal
c
ounterclockwise
i
nto the Left Crank Arm
(24). Tighten the Right Pedal (not shown)
clockwise
i
nto the Right Crank Arm (not shown).
I
mportant:
Tighten both Pedals as firmly as possible. After
using the exercise cycle for one week, retighten
the Pedals. For best performance, the Pedals
must be kept tightened.
Identify the Left Pedal Strap (25), which is marked
with an “L.” Attach the Left Pedal Strap to the Left
Pedal (22), and adjust it to the desired position.
Adjust the Right Pedal Strap (not shown) in the
same way.
8
22
24
2
5
INSTALLING THE RECEIVER FOR THE OPTIONAL CHEST PULSE SENSOR
If you purchase the optional chest pulse sensor (see page 9), follow the steps below to install the receiver includ-
ed with the chest pulse sensor.
Remove the access door from the underside of the
Console (4). Note: You may need a small standard screw-
driver to remove the access door.
Orient the receiver exactly as shown, and slide it onto the
indicated plastic pin on the Console (4). Locate the two
small screws included with the chest pulse sensor. Attach
the receiver to the Console with the two screws as shown.
Connect the wire on the receiver to the indicated wire on
the Console (4).
Reattach the access door.
Make sure that no wires are
pinched. Note: The other wires included with the chest
pulse sensor may be discarded.
Pin
Access
Door
Wire
Screws
4
Receiver