Filter
Top Products
5
2. While another person lifts the rear of the Frame (1),
attach the Rear Stabilizer (16) to the Frame with four
M
8 x 40mm Button Screws (54) and four M8 Split
Washers (55).
3
2
42
43
54
54
76
55
1
76
55
3. While another person holds the Upright (2) in the posi-
tion shown, connect the Upper W
ire Harness (42) to
the Lower Wire Harness (43).
Carefully pull the
upper end of the Upper Wire Harness to remove
the slack from the Wire Harnesses.
Make sure that the Upright (2) is turned so the top
slopes down in the direction shown.
Slide the
Upright onto the Frame (1). Be careful to avoid pinch-
ing the Wire Harnesses (42, 43). Attach the Upright
with four M8 x 40mm Button Screws (54), four M8 Split
Washers (55), and three Upright Spacers (76). Make
sure that the curved sides of the Spacers are fac-
ing the Upright.
4. Hold the Handlebar (3) near the Upright (2). Feed the
Upper Wire Harness (42) up through the indicated hole
in the Handlebar. Attach the Handlebar to the Upright
with two M8 x 25mm Patch Screws (59) and two M8
Split Washers (55). Be careful to avoid pinching the
Upper Wire Harness.
3
Hole
2
42
59
55
4
Do not pinch the
Wire Harnesses
(42, 43) during
this step.
Top must
slope down in
this direction.
Do not pinch
the Upper
W
ire Harness
(42) during
this step.
1
6
1
55
55
54
54
2