Filter
Top Products
6
6. Turn the Seat Post Knob (20) counterclockwise two or
three turns to loosen it. Next, pull the Knob, raise the
Seat Post (8) a few inches, and then release the Knob.
Move the Seat Post up and down slightly until the
pin on the Knob snaps into one of the holes in the
Seat Post. Then, turn the Knob clockwise until it is
tight.
Attach the Seat Bracket (7) to the Seat Post (8) with
two M8 x 25mm Patch Screws (59). Make sure that
the Seat Bracket is oriented so the slot is on the
indicated side.
7. Attach the Seat (9) to the Seat Carriage (11) with four
M8 Nylon Locknuts (63) and four M8 Split Washers
(55). Note: The Nylon Locknuts and Split Washers
may be preattached to the underside of the Seat.
Slide the Seat Carriage (11) into the Seat Bracket (7),
and move the Seat Carriage to the desired position.
Insert the Seat Knob (10) into the slot in the side of the
Seat Bracket, and tighten the Seat Knob into the Seat
Carriage.
8
59
Slot
7
20
5. Have another person hold the Console (4) near the
Handlebar (3).
Connect the Upper Wire Harness (42) to the wire har-
n
ess on the Console (4). Locate the ground wire that is
connected with a screw to the Handlebar (3). Connect
the ground wire to the smallest wire on the Console.
Next, locate the pulse wire extending from the
Handlebar and connect it to the corresponding wire on
the Console.
Attach the Handlebar Cover (5) to the Handlebar (3)
with an M4 x 16mm Screw (57).
Carefully insert all excess wires into the Console (4).
Attach the Console to the metal plate on the Handlebar
(3) with four M4 x 16mm Screws (57).
Be careful to
avoid pinching the wires.
3
5
57
57
4
5
6
7
55
63
11
9
10
7
Do not pinch
the wires during
this step.
Pulse
Wire
42
Ground
W
ire