Filter
Top Products
6 7
900Ub Upright Assembly Drawing
900Ub Upright Assembly Instructions
Step 1: Stabilizer Bars Assembly
Place rear stabilizer bar under rear main frame body and align screw 1.
holes.
Insert two M8 x 90mm bolts into the stabilizer bar all the way through 2.
and into the holes on the frame
Secure rear stabilizer bar using an M8 nut and a curved washer on 3.
each bolt.
Repeat steps 1 – 3 to attach front stabilizer bar.4.
Step 2: Pedal Assembly
Use a 15mm open-end wrench to fi rmly affi x the pedals to the cranks.1.
The left and right pedals are different and are denoted as right or left (R 2.
or L) on the top & bottom of each pedal.
NOTE: Left pedal threads counterclockwise.
Retighten cranks after approximately 10 hours of use.3.
Step 3: Seat Post and Saddle assembly
Loosen the seat pin by turning it counter-clockwise 1-2 turns. Install seatpost 1.
by sliding it into seatpost receptor, pulling the seat pin out until a suitable hole is
found.
Assemble saddle onto seatpost.2.
Tighten the affi xing nut and washer using a 17mm open-end wrench. 3.
SADDLE ANGLE ADJUSTMENT HINT: Hold the rear of saddle in the optimum
comfort position and tighten the nut at the same time
Step 4: Console Mast Assembly
Remove the console mast plastic cover from the unit's body 1.
by un-smapping it.
Install console mast cover onto console mast.2.
Connect the main wire harness in the main frame to the 3.
main wire harness in the bottom of the console mast, taking
care to install correctly. (See plug alignment marks)
Install the console mast by sliding it into the console mast 4.
receptor while gently pulling the wiring harness. This will
keep the slack out of the harness so the wires will not get
pinched and short out. Insert and tighten three M8 x 16mm
bolts, one fl at washer on each side and a curve washer on
the front using a 6mm Allen wrench. Be sure not to pinch
wire harness while tightening these three screws and make
sure that the two top holes are lined up with the holes on
the receptor.
900Ub.Sr OM.R1.indd 6-7900Ub.Sr OM.R1.indd 6-7 6/11/2008 9:56:03 AM6/11/2008 9:56:03 AM