Filter
Top Products
Assembly
Assembling is easy. Assemble the unit according to the following procedures.
1
Installing Front and Rear legs
• Attach the front leg (with casters) under the main unit, and
the rear leg under the seat base using two screws each, as
illustrated.
CAUTION: Be sure to fasten all the screws tightly.
2
Installing the seat and seat back
• Insert the steel pipe of the seat back into the seat base,
and fasten with the two screws provided. Place the seat on
the flat part of the seat base, and use the four screws to
fasten the seat from the bottom.
CAUTION: Be sure to fasten all the screws tightly.
3
Installing the handlebar
• Mount the handlebar as illustrated between the seat and
the seat back pipe, and fasten with the four screws. Install
the handlebar so the grip ends are lifted.
CAUTION: Be sure to fasten all the screws tightly.
4
Attaching the pedals
• Attach the pedals at the end of the crank. Identify R(right)
and L(left) of the pedal with the engraved mark. Use the
spanner wrench provided as illustrated to fasten the ped-
als.
CAUTION: Fasten the R pedal clockwise, and the L coun-
terclockwise.
CAUTION: Be sure to fasten the pedals tightly.
5
Loading the batteries
• Detach the control panel from the main unit. Carefully lift
the control panel while pressing the lock.
CAUTION: The control panel and the main unit is connected
by a cable. Any excessive pulling of the cable may result in
failures of the unit.
• Load the batteries (AA x 4) which come with the unit into
the battery case on the control panel. Check the polarities
of the battery and load them as shown in the drawing.
CAUTION: Do not mix old and brand-new batteries or dif-
ferent types of batteries.
• Install the control panel on the main unit. For this purpose,
insert the front part of the panel first.
Main unit
Control panel
Cable
Lock
Battery case
Batteries (AA x 4)
Seat base
Seat
Screws
Seat base
INSERT
#15 Wrench
Crank
Left(L) FRONT Right(R)
Rear Leg
Front Leg
(with casters)
Main unit
Seat base
Seat back
Handlebar
Screws