Filter
Top Products
Operation Guide 5182
E-50
Each press of x C in the home position adjustment mode will cycle through the
adjustment settings as shown below.
v
v
Left Dial Hand
b
Right Dial Hands
x
Second
z
Hour/
c
Minute/
n
24-hour
m
Day
When adjusting a hand or the date home position, it is recommended that after x
you move to a proper home position, you press B to move the setting back one
step. Next, press D again to return it to the home position. This helps to ensure
better home position adjustment accuracy.
E-51
After confi rming that the 2. v
v
Left Dial Hand is in the
correct home position, press C. This will switch to
b
Right Dial Hands home position adjustment.
The x
b
Right Dial Hands are at their proper home
positions if they both move to 24. If the hands are not
positioned correctly, use D (+) and B (–) to move
them to 24.
After confi rming that the 3.
b
Right Dial Hands are in the
correct home position, press C. This will advance to
x
Second Hand home position adjustment.
The
x
x
Second Hand is in the correct home position if
it is pointing at 12 o’clock. If it isn’t, use D to move it
to 12 o’clock.
*
@
>
E-52
After confi rming that the 4. x
x
Second Hand is at the proper
home position, press C. This will switch to
z
Hour
Hand and
c
Minute Hand home position adjustment.
The x
z
Hour Hand and
c
Minute Hand are at their
proper home positions if they both move to 12 o’clock.
The
n
24-hour Hand also will move along with
z
Hour Hand movement, and cannot be adjusted
individually. If the hands are not positioned correctly,
use D (+) and B (–) to move them to their proper
home positions.
+B
6
@
E-53
After confi rming that the 5. z
z
Hour Hand and
c
Minute
Hand are in their correct home positions, press C. This
will advance to day home position adjustment.
The
x
m
Day is in the correct home position if it
shows 1. If it doesn’t, use D (+) and B (–) to change
the day to 1.
Press 6. A to return to the Timekeeping Mode.
The
x
m
Day moves to the current day, and then the
z
Hour Hand and the
c
Minute Hand will move to the
current time. Wait until everything stops moving.
5
+B
E-54
Troubleshooting
Hand Movement and Position
■ I lost track of what mode the watch is in.
Refer to “To select a mode” (page E-19). To return directly to the Timekeeping Mode
from any other mode, hold down C at least two seconds.
■ The x
x
Second Hand is moving at two second intervals.
■ All the watch’s hands are stopped at 12 o’clock and none of the buttons work.
Power may be low. Expose the watch to light until the
x
Second Hand starts moving
normally, at one-second intervals (page E-10).
■ The hands of the watch suddenly start moving at high speed, even when I do
not perform any operation.
This could be due to any one of the following causes. In all cases, the hand movement
does not indicate malfunction, and should stop shortly.
The watch is recovering from a sleep state (page E-14).
x
E-55
The watch is returning to the Timekeeping Mode automatically from the Alarm Mode x
(page E-46).
■ Hands suddenly stop moving. Button operation also is disabled.
The watch may be in the power recovery mode (page E-12). Do not perform any
operation until the hands return to their normal positions (in about 15 minutes). The
hands should return to their correct positions when power recovers. To help power
recover, leave the watch in a location where it is exposed to light.
The current time setting is off by hours.■
Your Home City setting may be wrong. Check your Home City setting and correct it, if
necessary (page E-24).
■ The current time setting is off by one hour.
You may need to change your Home City’s STD (standard time)/DST (daylight saving/
summer time) setting. Use the procedure under “To confi gure summer time and other
Home City settings” (page E-24) to change the STD/DST setting.
E-56
■ The hands and/or day indications are off.
This could indicate that the watch has been exposed to magnetism or strong impact,
which has caused problems with proper hand and day alignment. Adjust the watch’s
hand and day home position alignment (page E-48).
World Time Mode
■ The World Time indicated by the b
b
Right Dial Hands in the Timekeeping Mode
and World Time Mode is one hour off from the actual time in the selected
World Time City.
The STD (standard time)/DST (daylight saving/summer time) setting of the selected
World Time City may be wrong. Select the correct STD (standard time)/DST (daylight
saving/summer time) setting (page E-42).
■ The World Time indicated by the
b
Right Dial Hands in the Timekeeping Mode
and World Time Mode is off.
Your Home City settings may be wrong. Check your Home City settings and correct
them, if necessary (page E-24).
E-57
Charging
■ The watch does not resume operation after I expose it to light.
This can happen after the power level drops to Level 3 (page E-10). Continue
exposing the watch to light until the x
x
Second Hand starts moving normally (at one-
second intervals).
■ The
x
Second Hand starts to move at one-second intervals, but then suddenly
returns to moving at two-second intervals.
The watch probably is not suffi ciently charged yet. Continue keeping it exposed to
light.
E-58
Specifi cations
Accuracy at normal temperature: ±15 seconds a month
Timekeeping: Hour, minutes (hand moves every 10 seconds), seconds, 24-hour, day
Calendar system: Full Auto-calendar pre-programmed from the year 2000 to 2099
Other: Home City code (can be assigned one of 29 city codes and Coordinated
Universal Time); Daylight Saving Time (summer time) / Standard Time
Stopwatch: Measuring capacity: 23'59.999"
Measuring unit: 1/1000 second
Measuring mode: Elapsed time
World Time: 29 cities (29 time zones) and Coordinated Universal Time
Other: Standard Time/Daylight Saving Time (summer time); Home City/World Time
City swapping
Alarm: Daily alarm
Other: Power Saving
E-59
Power Supply: Solar cell and one rechargeable battery
Approximate battery operating time: 6 months (no exposure to light after a full
charge and 10 seconds alarm beeper operation per day)