Filter
Top Products
E-43
To perform bidirectional calibration
1. In the Digital Compass Mode, hold down E
for about two seconds until the magnetic
declination angle value starts to flash. This is
the setting screen.
2. Press D twice to display the bidirectional
calibration screen.
• At this time, the north pointer flashes at the
12 o’clock position to indicate that the watch
is ready to calibrate the first direction.
3. Place the watch on a level surface facing any direction you want, and
press C to calibrate the first direction.
• xxx is shown on the display while calibration is being performed. When
calibration of is successful, the display will show OK and x2x, and the
north pointer flashes at the 6 o’clock position. This means that the watch
is ready for calibration of the second direction.
4. Rotate the watch 180 degrees.
5. Press C again to calibrate the second direction.
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l